Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After an upgrading our standby 9800 to 17.9.4a our DNAC integration appears happy, but when we provision from the UI we get the above warning. I haven't kicked any APs over to the standby pair yet to verify, but has anyone else seen this actually re...
We haven't been able to find where the timeout setting is for the Hotspot Portals. We have instances where previously associated clients return to a building after the endpoint has been purged from ISE, the WIFI session helper from the client OS aut...
We are running stealthwatch v7.1.1 and I can't seem to load the Swagger documentation from the SMC, I see the Lancope swagger title bar and favicon loading, so seems like the service is there but is serving up no content.Request URL: https://172.16.1...
Our deployment has the Active Directory Profiling Configuration enabled, and it appears to be working, I see the AD-* attributes for profiled nodes, but Active Directory is logging some interesting "errors" from our ISE node:05/12/2020 03:58:05 PM Lo...
The documentation still states that the APIs are read-only. Is that still the case?Cisco TAC hinted that it might be possible (but that they won't support it...)Thanks in advance!
We're seeing the same thing with 17.9.5. If we connect the gi0/0 port when the device is powered on, autoinstall won't ever pull an IP address - if we leave the other side shut until the switch fully boots, then we're good to go. Took a lot of debu...
I am going to dance around your question before I attempt to answer it.When we started our automation journey we didn't simply start managing thousands of devices as single units, but stepped back and built a foundation we could automate around. Som...
In my testing I was also able to confirm that if we're not making changes to a wireless profile, or editing the profile assigned to a site, although we received the message:Provisioning a Controller upgraded to version 17.7 or higher with WPA2+WPA3/W...
Thanks! I'm failing over one site today so I can confirm as well. If it's only a potential disruption if the config elements require a radio reset, it's frustrating they wouldn't word it as such.
