Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to take advantage of the processing power in a second RSP installed in a 7513.Can I utilize the redundant RSP in a 7513 the same way I use redundant MSFC's in a Catalyst 6500?Each MSFC in a 6500 operates independantly while running HSRP ...
I have a Catalyst 5500 running software version 4.5(10) on SUP 3's. I need to create an 802.1Q trunk between this switch and a Catalyst 4006. While the code supports 802.1Q, the switch will not allow 802.1Q on the ws-u5533 module and says the feat...
I would like to send calls over my point to point T1 between two locations. Can anybody tell me what Network Modules I need for the physical connection to the PBX's? I will use a 2600/3600 platform for my routers and a T1/PRI interface at the PBX.
Would I not need those commands for my VPN client to work?Could you elaborate on not using the "crypto map rmap local-address Ethernet0" command?Thanks
I am getting the following:3d11h: ISAKMP (0:0): received packet from 24.25.87.127 (N) NEW SA3d11h: ISAKMP: local port 500, remote port 5003d11h: ISAKMP: Locking CONFIG struct 0x818AFCFC from crypto_ikmp_config_initialize_sa, count 53d11h: ISAKMP (0:5...
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
