Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team,
We have Cisco 5508 Controller and Cisco CAP-1252 with Following software version:
Cisco Controller 5508 Software Version: 7.4.121.0
Cisco 1252 Software Version: c1250-k9w8-tar.152-2.JB3
As per Compatibility matrix, Software version pre...
Hi Professionals,I am able to configure the EAP session timeout parameter on Cisco Autonomous AP and WLAN Controller (5508) but not on Cisco ACS Radius server.Can please suggest me "How to configure EAP session time out parameter on Cisco ACS 4.2". ...
Dear Team, Configuration:i have 5508 series controller and joined the two Thin APs to the controller. WLAN controller is connected to PC where Multicast receiver is running for two Multicast IP addresses (IP1: 230.1.1.1, IP2: 230.1.1.2). Multicast se...
How to configure Catalyst 2960-s switch to allow communication between two Wireless Clients on two different VLANs. Couldn't able to do data transfer between two wireless clients.Test setup:Test setup includes Cisco 1240 AP, Catalyst 2960-s switch an...
Hi Saurav,Thanks for giving reply.Configured the EAP-TLS session timeout on Cisco ACS 4.2 and configured the Cisco AP for use session timeout configured on Radius server (dot1x client-timeout server) then also EAP session timeout is not affecting.If ...
Yes , I agree with you but If we want to send manual RM-Request then this hidden command (test aprm ...) mandatory. Is there anyway to enable this command.Thanks ,Harsha
