How to configure IP Address filter in Controller based Access Points ?

[Harshavardhan ch]

Dear Team,

Configuration:

i have 5508 series controller and joined the two Thin APs to the controller. WLAN controller is connected to PC where Multicast receiver is running for two Multicast IP addresses (IP1: 230.1.1.1, IP2: 230.1.1.2). Multicast sender is running for two IP addresses on Station.

Requirement:

When Station is associated to AP1, AP1 should block the multicast packets going to AP2 and vice versa . That is AP1 should be configured to block multicast packets going to 230.1.1.2 and AP2 should be configured to block multicast  packets going to 230.1.1.1.

Thanks,

Harsha

[Moin Ilyas]

I believe you could apply ACLs and check if that helps.

For more details about configuring ACLs, please refer to the following link:

http://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/b_cg80/b_cg80_chapter_0110101.html#task_AA3AFA57D51647478E0C3511137C165E

Hope that helps.