Hello;My system is composed of: UC560 +2 cisco 6901 ip phones+ 2 cisco 7945 ip phones. I use CCA 3.2 (3) for the configurationwhen I started the setup with the telephony configuration wizard  , the system has detected only two phones cisco 7945. so I...

HELLO when I try to session CUE the system asks me to authenticate. when I use the default credentials  of the uc (cisco / cisco) nothing happens ans this is the Result; UC560 # service-module Integrated-Service-Engine 0/0 session Trying 10.1.20.2, 2...

Hello;I am working on a UC560.When I run the telephony setup wizard, it informs me that I have a problem and that I should reset factory default the system.When I try to reset the system from CCA i obtained this message "Reset Cue failed"I try to res...

Hello;I am working on a UC560.When I run the telephony setup wizard, it informs me that I have a problem and that I should reset factory default the system.When I try to reset the system from CCA i obtained this message "Reset Cue failed"I try to res...

hello;i have an ipbx cisco u520.i have 1 pstn line and 1 gsm gateway.When i call a mobile number and the line (gsm gateway)is busy , the call is established from the pstn line.i would like that the calls to mobile phone will be made only from the gsm...