Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What I witnessed was a very long microcode “programming” when going from the 15 to the 12.2 in About 25 minutes but I did not time it.I would assume if it had to do that it was downgrading microcode to meet the 12.2 specification.Another switch setup...
Old post but figure worth mentioning.. I had to add a switch to an old stack and downgrade from 15.2 to 12.2 before adding and it absolutely does microcode programming so plan for the extra time.
Can you provide details/cli commands on the dropping vertica part? I am having a similar issue and product is EOS. We need to refresh hardware it but that will take time. any help appreciated. Thanks
Old post but I figure if someone searches they can quickly see what worked for me... I too got that same message. I entered "switch 1" at the end and it kicked off without issue. note this is a single switch with no others provisioned...Switch#sof...
I can confirm it is NOT fixed in 6.2(27) as I recently upgraded to fix another bug and currently have the same issue. And yes they recommended the code which has the same messages. Constantly in the logs:Nov 12 09:59:57 %KERN-0-SYSTEM_MSG: [1422598...
