Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am able to update SPA504G firmware using a PC on Win-7 just fine.I am asking this question on behalf of a client, who says they can't follow the instructions I gave them for updating firmware on his SPA504G using his Mac computer, because he says ...
This document was a life saver for me today. Thank you for creating this document on how to configure MAC Filtering on the WAP371. I could not figure out how to get MAC Filtering to work on my WAP371..... until I did the research and found this doc...
Hi Sergio,Make sure you have enabled "Use Outbound Proxy" to "YES".Unless BT instructed otherwise, make sure "Use DNS SRV" and "DNS SRV Auto Prefix" are both set to "NO".Unless BT instructed otherwise, make sure "Auth ID" is blank, and "Use Auth ID" ...
Hi Sergio,A couple years ago I wrote the following blog article on how to configure the SPA504G from scratch (using CallCentric as the example VoIP provider for configuration).http://blog.voipdiy.com/2011/11/configuring-cisco-spa504g-ip-phone-from.ht...
Hi Brian,According to the SPA112 adminsitration guide, *67 will permanently set the line to block Caller-ID.And, *68 will permanently remove the block on Caller-ID. Perhaps try removing the block on the lines by using *68 and see how outbound dialing...
Which VoIP provider are you configuring the ATA with?Some settings vary from VSP to VSP, but for the most part most settings are the same.I can suggest a few things to check that may help with these issues.1.Enable NAT Mapping Enable NAT Keep AliveEn...
