Does it matter the nat syntax for a subinterace?1. ip nat inside source list 1 interface serial0.1 overload2. ip nat inside source list 1 interface serial0:1 overload ?

I configured basic NAT for a 1700. When I go and runshow ip nat trans I see outside & inside local and global transactions in the form of icmp and udp only - no tcp connections. Like I said b/4 I placed basic NAT&PAT statements so I could rule out ...

mac-address-table static xxxx.xxxx.xxxx fastEthernet 0/10 vlan 201Is this the correct syntax to hard code a device on the 3548 switch?

Can anyone provide me a sample for the community strings used by the ANI Server that they have used for their network? The syntax Ciscoworks 2000 lists is as follows:target:read_community::timeout:retries::::write_commmunityThis is just a little amb...

I just finished installing CW2K Edition 2, ammending the snmp strings on my hardware and am in the process of setting up my network for these strings so I may discover my network devices. Is there any documentation on how to do this besides the help...