Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been playing with sdwan in eve-ng with the topology below. I already bring up the tunnels and can see both sites up to vpn0 from each other. still getting use to and practicing with templates but i really having difficulties in how to send t...
I have a wan router(70.70.70.129) from where I need to access a syslog server on inside with its real ip address(192.168.1.192). I have setup an access list on outside int:access-list outside_acl extended permit udp host 70.70.70.129 host 192.168.1.1...
I have added an LDAP Directory Group on Jabber via GUI which display all my users, is there a way to add this via config.xml so it can be deploy to my enterprise ? Thanks !
I have a doubt i am implementing qos on my network from different remote sites to my hq connected through MPLS. the parent policy is applied to the output of two subinterfaces. the markingTraffic policy is appied to the input of the lan interface
do ...
HI,I am pretty raw on layer 3 qos and I want to know if I'm missing something or which one is the easiest/best way to do this. I have a cisco c881 on my provider MPLS network and am trying to do qos from router on location1 to router on location2.I a...
since there is no route leak, i am suppose to get to each other from vpn 10 ?Ex. ping 10.40.40.x vpn 10 site 200 show ip routes vpn 10
Codes Proto-sub-type:
IA -> ospf-intra-area, IE -> ospf-inter-area,
E1 -> ospf-external1, E2 -> ospf-external...
yes, but weirdly enough after removing the policy from vsmart I still have access between sites. Maybe the policy insert routes and leave it there even when I already removed the policy I even restarted the vsmart and vEdges ? show control connecti...
Well I was able to do it with an extranet policy in vsmart but is this the correct way ?policy
lists
vpn-list client_vpn
vpn 10
!
vpn-list transport_vpn
vpn 0
!
site-list all_sites
site-id 100
site-id 200
site-id 300
!
!
...
@Sheraz.Salim @Francesco Molino First thansk for the support, help and patience. reading your suggestions I realized my error, In the NAT rule I had created I leave any instead of specifying the port 514 now internet on the monitoring tool and the s...
