Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,I'm trying to get Cisco's recommended approach on the placement of the DNAC Witness node in Azure for Disaster Recovery Implementation but could not find any document that covers this.Is the below plausible and supported deployment by C...
Hi all,We have a medium deployment with PAN+MNT personas sharing the same appliance. If I want to restart the PPAN due to resource utilization. Can I promote my SPAN to the new PPAN while the "PAN Auto Failover" enabled, and reload the original PPAN?...
Hi Community, Having an issue where the SD-Access switch is detecting dual MAC addresses from two different VLANs. At this point, I'm guessing it's a client-side ( voice device) issue but would like to hear if anyone comes across such scenarios. Swit...
Hi Community,In a Cat9300L switch ( IOS XE 17.6.4 ), can see some high CPU and packet drops. Any leads to nail the actual root cause appreciated.Switch-1#show controllers cpu-interfacequeue retrieved dropped invalid hol-block-------------------------...
Hi Ciro, I have similar requirement. Which option you have proceeded with? Autonomous AP is discontinued. My requirement is less than 10 APs and deploying WLC feels overkill. CheersSaj
Thanks Torb for the response. Found this Cisco Live slide deck which mentioned latency to be less than 350 ms.In our case, latency is less than 100 ms.
Point taken Arne. Only use case i can think of is failing PPAN in out-of-hours and you want working PAN on next working day. I would think disable Auto PAN Failover and giving a reboot the PPAN is the way to go Once PPAN is up, then re-enable the Au...
Thanks Arne for the response. Do we have to disable the "Auto PAN Failover" before restarting the PPAN ? I'm thinking if SPAN promotion gets kicked in while PPAN rebooting.
