Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have joined ll Ap 9105axi but the 9124axi is not working.
First it was saying there was a different version of firmware. I have updated succefully the firmware but from that time on it did not join.
I have an installation of several access point wap561. I had to split the network in 2 clusters because of the amount of access points so I have a cluster in the groundfloor and ote in the basement. Both with the same configurations.I have created a ...
The new 9124AXI i was trying to configure was in EWC mode and conflicted with the EWC that I already had.
I configured the EWC again and put the 9124AXI in CAPWAP before trying to connect to the EWC.
I have requested TAC as the EWC seems odd. it stopped working and gives an error saying "filure to run nvram". Now i don´t know if the problem is really the 9115.
Thanks
Well, it seams a SSID problem. When i make 2 separate networks, the 2.4G gives speeds of 30~20 Mbps and the 5G gives 90Mbps.If i put both with the same SSID all decreases to 30~20 Mbps.Also that happens mostly in apple devices as my computer is alway...
