Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Friends, I have 2 C9500-40X switches with virtual StackWise configured with version 16.8.1a and I have had some problems:- When I try to configure a vlan I lose connection of the session.- When I access by Telnet / SSH I sometimes get the messa...
Hello, I have to migrate from 2 swithces multilayer to 1, each switch has a different configuration and you have the following SVISW1Vlan100 interface description << VLAN WAN INTERNET >> ip address 189.206.125.253 255.255.255.248 standby 10 ip 189.20...
HI ALL, I am configuring a project with APs 1562 in WGB mode with Mobility Express but I need several VLANs to pass, it is already connected to the SSID but only one vLAN passes and I need several VLANs to pass. Does anyone know that it has to be con...
It was already clear to me that the configuration has to be done from the active switch since in standby it will not let me do any type of configuration and here the following problem enters that I also only have on the primary switch, can I enter th...
Hi Guiseppe,Thanks again for the time.It is impossible to keep old switches as new switches will be purchased for the performance and throughput. And then I can't use vrf because of the incompatibility with wccp.Question:As I said, I have 4 switches ...
Hi Giuseppefirst of all thank you very much for the answer,I have some questions:* On the ACL suggestion:Extended access list VLAN69-INdeny ip 192.168.1.0 0.0.0.255 189.206.125.248 0.0.0.7deny ip 192.168.1.0 0.0.0.255 10.150.40.0 0.0.0.255deny ip 192...
