Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,I got Cisco Anyconnect VPN (with Split-Tunnel) client installed on Window 10. The VPN solution is being configured on Cisco ASA. On some Windows 10 clients the users are unable to resolve internal hostnames. The DNS servers being pushed throu...
Hi there, I got a Cisco router on which the ISP line is terminated. I have connected Cisco switch to the router. At this moment I got one VLAN on the switch and DHCP is being done from the router. I would like to create two extra Vlans on the switch....
Hello, I've deployed Cisco FMCv & FTDv in Azure by following this document:https://community.cisco.com/t5/security-knowledge-base/high-availability-and-scalability-design-and-deployment-of-cisco/ta-p/4109439As the static routes are concerned, differe...
Hi Team,I have configured Cisco Anyconnect VPN on Cisco FTD being managed by Cisco FMC. The Cisco Anyconnect VPN is working fine with AAA (local) authentication. But now I would like to change the authentication method to Machine Authentication. I ha...
Hi Team,I have Cisco Anyconnect VPN client configured on Windows 10 machine. The DNS addresses (internal DNS server) are being pushed correctly after the Cisco Anyconnect VPN connection has been established. When I execute nslookup it's resolving the...
Thanks for your reply. I have compared the ipconfig/all in both situation and it's the same. When the issue occurs, I usually do nslookup and I can see the one of the Corporate DNS servers but it fails to resolve the hostname. When I disconnect and r...
Hi B.B,Thanks for your reply. Below you can find the answers to your questions:what is your DSL Lan IP address range?172.16.1.0/24what is your VPN pool allocation IP range ?10.55.1.0/24what is your coporate DNS Server, when you connect VPN, ipconfig ...
Hi BB,Thanks for your prompt reply. The switch is also a L3 device but I know you can't do NAT on a switch. Do you have an example of what you mentioned?"make sure you add ACL to all the VLANs IP addresses to be added to NAT to get internet"Thanks.
Hi Team, Thanks for the article. I have configured the NAT, ACP and static routes exactly as shown in the article but sometimes the health probes from Azure eLB & iLB goes down and no traffic is being routed towards the FTDv's.What can I check and ho...