Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I installed the Openflow Plugin on a Cisco 3650 switches, and recently have to do a factory reset. Now I can tab commands for openflow, running them in config terminal without a single error, but when I check the plugin using "show openflow <a...
Hi all, I have a Catalyst 3650 running IOS XE 3.0.7. How to do a factory reset using CLI without wiping the flash? I have saved a number of config saves on it and want to preserve the flash intact. I have both physical and CLI access.Thanks,
Hello everyone, I have a network of two hosts, connecting to a Catalyst 3650 switch, which connect to outside network.The two hosts can ping each other, have known IP address (172.16.11.x) and same subnet. However I am not able to ping the host from ...
Yep, the virtual-service command verify that the service was just deactivated and still in system. A simply activate command made it work. Thank you very much.
