Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a question about the WAN-1 port on a Meraki, does it need a default route to connect to the internet?Suppose i have the below topology, the WAN-1 port is allowe to internet but has a private IP, remote sites connect on the private IP using ...
Hi,Just read there is new integration available with NSX-T SDN controller from ACI version 5.1.Cisco ACI and VMware NSX-T Data Center Integration - CiscoBesides this there is not a lot of information available for this. Is there any good reference a...
Hi,I have the following situation described in this article: "https://www.bytesofcloud.net/2018/10/ospf-vpc" show ip ospf neighbors vlan 387OSPF Process ID 1 VRF defaultTotal number of neighbors: 4Neighbor ID Pri State Up Time Address Interface10.25...
Hi,I have a question about Auto-VPN.In HQ I have a meraki MX-250 connected to the internet via it's WAN port 1. And i have another port LAN port connected to the Datacenter.(MPLS network). I want to establish a VPN over the MPLS only.Will the Auto-...
Hi, I have a question about the Nexus 93180YC , i want to have 2 of this in my POD(RACK). And connect this to the 7K core layer. The 9K will be functioning as access layer for servers in the rack.This is 9k in non ACI mode but in traditional NXOS ...
Hi,I need to have a directly connected subnet. On one end of the firewall. Must be seperated physically. Otherwise i would Go for one armed would make my life easier.
Hi Greenman,Yes in considered placing it as One armed but this doesn’t suit my requirements. The wan ports will have private IP but with outbound internet access otherwise autovpn will not work. The tunnels will formed on private IPs then. Frederik
Hi, thank you already had that one. The new version 5.1 realy integrates the NSX-T controller. If my understating is correct this actually pushes aci objects to NSX-T. For example EPG --> to Segment in NSX-T.Could it be that this approach uses V...
Hi Karthik, I am assuming you want to authenticate your users on your company WIFI infrastructure. I don't know of any step by step guide but for certificates you will have to look at SCEPhttps://docs.microsoft.com/en-us/mem/intune/protect/certifica...
