Hi,I'm trying to find out if any of LTE versions of C819 can work in Mexico.I don't need LTE connectivity, 3G is sufficient. I only need to use 4G HW version because of build in external antennas in a vehicle.Any idea? Thanks. Karel
Hi all,I have a problem with high cpu utilization - SW switching on 3560G-24TS but I can't find the reason.There is only one access list with no log option used with PBR.sh proc pcuCPU utilization for five seconds: 26%/20%TCAM is not fullFollowing de...
Unfortunately, I'm afraid to trust only data sheets so I'm looking for some tested deployment.From wiki http://en.wikipedia.org/wiki/List_of_mobile_network_operators_of_the_Americas#Mexico it looks like these bands are used:850/1900 MHz UMTS, HSDPA, ...
Hi,your provider could use dot1q tunneling to allow you to use trunk connection between your switches.If your provider have pure access port you can do almost nothing with cat 4500.You can do e.g. L2TP tunnel with different HW.Regards,Karel V.
Hi,you are right. You have to assign IP to VLAN interface (SVI) and these two port add to this VLAN.You can do "multi-chasis" etherchannel as you mention.Regards,Karel V.
If an access port receives a tagged packet (Inter-Switch Link [ISL] or IEEE 802.1Q tagged), the packet is dropped, and the source address is not learned. http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_58_se/configurat...