Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello Everybody, today i have got repeted on 15 sec this message on asr9k: %ROUTING-FIB-3-PLATF_UPD_FAIL : FIB platform update failed:
Obj=DATA_TYPE_NHINFO[ptr=b55c60f8,refc=0x3,flags=0x3] Action=MODIFY Proto=ipv4.
Cerr='FIB' detected the 'warning...
hello guys,i've got a very strange problem, my cisco asr1002 BRAS disconnect me randomly after a couple of seconds from telnet/ssh from a pc directly connected to gigabitethernet 0 interface(off band MGMT) and also inband. i've updated also firmware ...
hello,
i have a problem in establish a lacp bundle from asr9k to 2x nexus 3k in vpc.
when i try to esatblish the channel without vpc everithing work correctly when i enable for example vpc 3 on port-channel on nexus the link go down and nexus say...
hello, i have setup an ipsec vpn with a partner of mine that ask me to present my lan with this class 172.31.128.244/30 with a destination lana of 161.x.x.160/28. then i configured an ippool nat for vpn: ip nat pool VPNPool 172.31.128.245 172.31.128....
hi guys, a customer have 2 pix 525 with ver 7.0.1 in a failover configuration with serial cable and 2 sc fiber interface and 2 fastethernet 1 used for failover.the strange behaviour is that when i try to do traffic from inside to dmz or dmz to insid...
Hello,Thanks a lot for reply. I think the big is not this one exactly because the error is slightly different.Nevertheless how can I solve the problem i cannot update my ios xr because the rp 8g is at 5.3.2 and it is the latest available. Any suggest...
hello Rick, sorry didin't understand why you need ips from interfaces, i say in my post that in the gi0 with vrf mgmt telnet/ssh get disconnected after some second, the same happens on other interfaces.the gi0 has another vrf then all other interface...
hello, here the output of show line and the configuration: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 0 CTY - - - - - 0 0 0/0 -
1 AUX 9600/9600 - - ...
Hello Rick, Thanks for the reply. I'm not understand you points. When I connect in ssh trough a pc directly connected to asr in Port gi0( the mgmt port) the session disconnect in couple of second from the cisco I cannot debug for 2 min...My post say ...
Hello Rick, The original output was captured when ssh has been dropped with the message you see in the cli above the debug. It seems that something is wrong on tty. But I don't understand what. I can remove all tty conf, but already tried with no luc...
