Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I spent some time on LMS and found LMS can create a report representing which devices' configs had changed for last 24 hours. Does anybody know if it's possible to create a report representing which configuration changes have done for last ...
Hi there,Is there a way to configure promiscous trunk port on Catalyst 3750 switch?I couldn't find "switchport mode private-vlan trunk promiscous" command in my 3750. It has only "switchport mode private-vlan promiscous" and "switchport mode private-...
What is the meaning of operating temperature under environmental conditions mentioned in product sheets: If the temperature of the device that feels or the temperature of the room that switch works in?
Hi there,I have two identical CiscoWorks 2000 servers with the following components installed:- CW Common Services SP3 2.2- Monitoring Center for Performance 2.0.2- IPS Management Center 2.1- Resource Manager Essentials 3.5- Resource Manager Essentia...
Hi there,I have LMS running on a server but unfortunately, I can't login to my LMS. At the home page as you know there are three parameters to check: JavaScript = EnabledJava = EnabledCookies = DisabledI have an other server just the same configurat...
To explain more detailed what I’m trying to get is:Reports>Audit>Change Audit>24-hour Selecting all devices and CONFIG_CHANGE as category in the Selection Criteria gives most of the things what I want. The only but important thing I want to see addit...
Hi Reza,Yes I have the same result. But I 'm wondering if it is related with IOS or chassis. I mean is it possible to have this feauter/parameter with an other IOS version of 3750 or it's impossible.Nexus 1000V and Cat 4500 has the "switchport mode p...
Thanks for your message Reza. I know the functionality of primary VLAN. But I want the same port to be Promiscous port and trunk at the same time. Because my gateway for all of my VLANs is connected to that trunk port. On the other hand one of the V...
Hi,then you mean that "show environment status all" command should show lower temperature values than operating temparature of device mentioned in product sheets?I mean product sheet says it must be between 0 and 40C, but "show environment status all...
I solved the problem by stopping and restarting the "CiscoWorks Deamon" from services. This may be an installation problem. May be some services don't start in the regular order. Any idea?Best regards,Yasemin.
