Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am looking for step by step procedure for installation, configuration, integration Cisco Unified Attendant Console Advanced with CUCM 14.
Also need to know from where to download CUACA 14 Server and client setup. If possible also please ment...
I am deploying expressway Setup for MRA & B2B.
Internal & External Domains are different.
Internal: example.in and External: abc.com
I have deployed Expressway in Cluster.
Expressway C: 2 Nodes.
Expressway E: 2 Nodes. (Dual NIC)
Domain configured ...
Hello Everyone,
I need assistance regarding CUCM integration with CUE(Service Module on Router) and Call Handler configuration in CUE. Please find below requirements,
1. 1111 is the Pilot number(Board Number on which incoming calls are landing)
2. ca...
Expressway Version X12.5.1I have an Expressway - E in my setup using it for MRAI have got an error as mentioned in title. " Next Restart will trigger the factory reset". Please note that we were having two nodes in Expressway Cluster in past but now ...
Hello, Does Cisco Unified Attendant Console standard supports MAC operating system as receptionist who will user Attendant console has iMAC system. SachinS
I have configured example.in domain on both expressway E nodes
Exp-e1.example.in and exp-e2.example.in which resolves to internal interface and this fqdn are used as while exp-e Clustering as well.
is it ok if i configured both internal and external ...
Hello Abdul,
I am also seeking for solution for same scenario. Calling to and fro between on prem CUCM and Webex cloud calling.
If you have deployed this solution, could you please share in details steps or any specific document you have with pre re...
Ok. But now my exp- e is standalone and it Clustering is set to off. In this state, is it ok to set On Cluster Mode and restore the Clustering peer address field.? Thanks
Thank you for your reply. This node is primary and in production.We have removed other node from cluster but this error is reflecting on primary node. i am concern as this is my primary node and will get factory reset if restart. in this case how i c...
Hello Alok, Thank you for your reply. Can you help me with the detail procedure (steps) to move Expressway C & E from BE6M to BE7M with backup and restore. Thank You.
