Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I am trying to understand why i am getting a drop rate on this class whilst it is <50% utilized. I have not tried changing the hold-queue or tx-ring-limit as of yet as there is a lot of traffic that utilizes this port so would prefer to get ...
Hi All,I am looking for a bit of assistance regarding the configuration of a SIP trunk on a CME installation. I have no previous experience with SIP (apart from what i have read on Cisco.com) and would like someone with more experience to highlight ...
Experts,I am trying to put together a "simple" SIP trunk test setup between a 3900 with CME/CUE and 2800 which is acting as an SIP ISP.My aim is to configure an inbound calls SIP trunk but I am having problems getting SIP configured correctly. I hav...
Hi all,I am wondering how I can initialize the Unity Express GUI without using the Wizard. I have configuration already on the unity module and not keen on having to factory reset it and configure it all again so wanted to know how I can enable the ...
Hi,I think I made a mistake when trying to license the CUE NM. I used the router SN instead of the CUE NM Serial number. I have tried to relicense it using the CUE NM Serial number but still getting the same error.Am I still using the wrong Number?...
Sunil, Martin & Joseph, Thanks for the feedback. This circuit is a bit different as it is running over satellite so there are incurred latencies that you would not normally expect to see. Ultimately you have confirmed my initial thought of needing ...
Hi Rob,Thanks for getting back to me. After a little more research on the net I found out what you have stated in your post. My PID should have been NME-CUE.I now have the issue resolved but thanks for your feedback.This is the 1st time I have used...
I was perhaps a little quick to post on here....I have found the issue.....I was missing the bridge-group 1 command from vlan 1. Added that and all is working
