Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Not sure if I am in right community... please add this thread to the right one. Thanks! +++ UC540 has 2 VLANs, 1 for data and the other for voice. I want to remove data VLAN and let UC540 continue with our telephony.I want Edgewater's EdgeMark 4700 t...
HelloI will have 4 DIDs but would like to configure SPA504G so that users can call out from 3 lines only. The 4th line is to be exclusively used for inbound calls.How is that done?Thank you
Hello expertsWe have UC540 and SPA504G phones. Incoming calls ring straight through on all lines on all phones. No hunting, no auto attendant.The last person to leave the office in the evening must enable call forwarding on all four TN's to an Answer...
Thanks great, AlexSo now I have "shutdown" to disable interface VLAN 10 and "no shutdown" to enable VLAN 10 To "stop" DHCP server I would use "no ip dhcp pool DATA VLAN". How do I "restart" DHCP pool Data VLAN...Also, should the syntax reference VLAN...
And hello again, AlexI tried the CLI commands but these were all returning errors. I tried listing the commands and there is no 'shutdown' command. Please see the attached .pngAwaiting your response... thanks!
Thank you Alex...Your reply is highly appreciated. Although I am not conversant with CLI commands, I know I can get there with PuTTY and you have given me all the necessary commands.Can you please give me the commands to reverse the shutdown and rest...
Thank you PhilippYour reply is very much appreciated. I will be reading through the article to understand the concept fully.In reply to your question, there are 4 incoming phone lines and 8 phone sets. Any call coming in on any phone line rings to al...
