Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to route 2 networks through 4431 out separate interfaces.
I currently have a default route -
ip route 0.0.0.0 0.0.0.0 10.50.0.9 (G0/0/0)
Now, I need VLAN 50 traffic to route to G0/0/2 specifically.
!interface GigabitEthernet0/0/0ip address 10...
I am hoping this will find someone that has experienced issue before or has an idea where to look?
I have one site having call issues with SIP based calls, with the following conditions:
They will receive a call and only hear one way audio - but not ...
I have an older Cisco 2960 Catalyst switch that has been in operation for years with 7962 phones behind it. The config has not changed and all of a sudden I have begun having trust issues with the phones: May 8 21:23:25 EDT: %SWITCH_QOS_TB-5-TRUST_D...
I have user with older system running on MSC hardware. The CUC VM died with vmdk errors.I build a new CUC and was able to get it running, however it will not 'see' and import the CUCM users that already had accounts on the old system. I can only se...
Good evening. Looking for anyone that has experience, tips, info on PCI compliance and how it may pertain to the Meraki MX64. I have a small body shop as a customer and they had PCI compliance test done and failed.The vulnerability was:Internet Key...
Paul,Did check that, do not appear to be any issues. CET_ALX_2960#sh power inlineAvailable:370.0(w) Used:137.2(w) Remaining:232.8(w)Interface Admin Oper Power Device Class Max(Watts)--------- ------ ---------- ------- ------------------- ----- ----Fa...
Nithin, that is already in place from before. Seems like there is a trigger or place holder on the CUCM flagging the user already has vm and doesn’t pull them over. a brand new user was created and pulled through LDAP, I assigned extension and associ...
