Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I will configure Cisco router 3825 at WIC slot 1 to support 2 T1's circuit. We already have aT1 link @ WIC slot 0 of the router which is configured on the serial interface.I need to know if i configure the following to support the new 2 T1 circuit...
HiWe have one VWIC2-2MFT-T1/E1 card installed at 3825 router at VWIC0 slot.When "Sh Controller T1" command is issued I can see the interfaces T1 0/0/0 and T1 0/0/1.Q1. Is these 2 interfaces indicates the 2 ports on the VWIC2 cards? Now if i install a...
Hi,We have a cisco 3825 router with OS version 12.4 and one VWIC2-2MFT-T1/E1 card at Slot 0.Now I have to add one more card of the same type in the router.I need to know the steps or process to add the the 2nd card in the router.Tthanks
Hi,I have a stack of 2 switches with IOS version 12.2(25) SEE4 and want to add one more stack in the switch which has 12.2(44) SE5 image.1. Do I have to load the existing image to the new switch first before adding to the stack?2. If loaded the image...
I have no knowledge on loop test. 1. Can you please explain what is loop test and how it works?2. After I connect to the circuit, how do I configure T1 controller, serial interfaces and how do i do the test? Can you give examples from scratch after p...
Hi Toshi,What is the default inteface type after a new interface card is installed to the router? [Is it card type T1 or card type E1]I am still not clear on the "card type" command.The 2nd card will be also for T1 and I have understood the "Controll...
Hi Toshi,I was discussing with Mr. Reza regarding this issue and he said that i do not need to give "Card type " command to the router and the new card type information will automatically apear. I am now confused what to do.Can you please let me know...
Reza,Thanks for the information.1. What does the 2nd 0 and last 1 means for Controller T1 0/0/1?2. I will not be connecting the new T1 line to the new interface card for now so if I issue the "no shut" commnad for T1 0/0/1, will it cause any issue?Th...
Hi Reza,In my router configuration I can see,card type t1 0 0 [ Is it because a card is installed at slot 0?]1. And as you said after i install the second card at slot 1 will I see " card type t1 0 1" in the router configuration or i have to add "ca...
