Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The subject doesn't explain the whole situation,I am bridging three locations in my building using pairs of 1GB ports on C4948 switches. In this case, I have two 'all vlan' trunks on port 1 and 2 from Switch A to Switch B.Switch A is already configur...
I'm attempting to bridge two locations.One is on the third floor of the building with a number of vlans.The other is in the basement (a C4948).I want to trunk the vlans from the third floor down to the basement.Once they are trunked down there, I wan...
I have a WS-C4948 and want to have it use two of its SFP slots instead of the GigabitEthernet port 47& 48.I have put in two glc-lh-sm in SFP slots 45 & 47 and have them connected to a C3560G-24TS which also have two glc-lh-sm installed.I cannot figu...
I am looking to bridge a Cisco WS-4948 to a Cisco C3560G-24TS elsewhere in the same building.I have a fibre patch panel that links the two locations which only has connections for single mode fibre.As the connection between these two switches will on...
I have a cisco catalyst 3020, and am in the process of attempting to set up IPv6 stateless DHCP.The 3020 is configured as follows:sdm prefer dual-ipv4-and-ipv6 vlang0/19 : switchport access vlan 2g0/17 : switchport access vlan 13g0/11 : switchport mo...
Thank you very much fzamora, I believe you deciphered what I was trying to ask =]Subnet1.Switch1.vlan1-----trunk.dot1q.nativeVlan100-------|Subnet2.Switch2.vlan1-----trunk.dot1q.nativeVlan101----SwitchA===trunk.All.sfp===SwitchB===.......Subnet3.Swit...
Thank you Roman, I am aware of access mode and trunking with allowed lists.I want to take all the VLANs in Site A that connect to Switch A,Trunk Switch A to Switch B,In Site B, I want to take the VLANS that were trunked into Switch B and send them ou...
Thank you Tom,I'm incredibly unfamiliar with using SFPs in Cisco switches.I've plugged the GLC-LH-SM SFP into the WS-4948 and logged into the console with root.Now I'm stuck in the position that I cannot find a configuration guide, nor can I see wher...
Again many thanks Guiseppe and your patience is very much appreciated.>>int g0/11>>switchport>>! this may be not supported if the blade supports only 802.1Q>>switchport trunk enc dot1q>>! this allows to specify the list of permitted vlans>>switchpor...
