Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Site to Site IPSec VPN unable to establish tunnel, below is the debug report. Steps as of now i done.cleared cryptoreconfigured 047900: *Feb 22 20:55:06.351 PCTime: IPSEC:(SESSION ID = 2) (key_engine) request timer fired: count = 2,(identity) local= ...
Hello My Dear Friends,How to identify route poison on my router where EIGRP configured with DMVPN.What problem will come with route poison. Let me know if you need any output from my side. Regards,Mahi.
Hello All,I have copied the configuration from router 2911 to ISR4331 i have copied everything except chain, please see the below sample config, i have two commands "crypto pki certificate chain TP-self-signed-1496608557""certificate self-signed 01"...
Hello Dear Friends,Observing increment in unknown protocol drops on C2911/K9 router Gig0/2 interface where IS cable is connected,I have checked tx / rx load is normal,reliability is good, not found input/output/CRC errors. We are not observing drops...
Hello My Dear Friends,I have C800 router, created a vlan and assigned a network with 14 available IPs, so site side they will connect there devices to the router and they will assign IP from those 14 IPs, now the problem is there is device called E-G...
Hello my dear friends, Thanks for your responses. @leo:it's not a trunk port plese refer the below config.It's not only concern about the unknown protocol drops, if the drops are because of DTP, when we are pinging to the DC server IP we are observin...
Hello Teams, Thank you all.How to find OM type, i know only it's multimode fiber cable connected between C9300 to C9200 with distance of 100 meters.I suggested to my a multimode SFP according to the switch model from cisco brand(To avoid incompatibil...
@paul driver @Georg Pauwen : Thanks for your both the response.@paul driver : Unfortunatly it's not possible to assign the IP on end e-guard device device, i don't have other option.@Georg Pauwen : it's somedevice i heard it can take ip only via dhcp...
