Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a GRE/IPsec tunnel going from 1 router to a Cisco. I'm able to ping across the tunnel, so I know that communication is working. If I ping 8.8.8.8, it fails. If I traceroute it, the traffic is stopping at the far side of the tunnel at the GR...
I have 2 cisco routers that should be using GRE back to 1 other device. When I check the status of the interfaces I can see that on one, the status is up/up. On the trouble one, its showing the status as 'reset'. I'm not sure what that's referring...
I have a tunnel set up with a 10.22.32.1 address on one side, and 10.22.32.2 on the other. So, a GRE/IPsec tunnel, sharing some routes, and that part is fine. From the non-cisco side I can ping across the tunnel to the cicso, and if I traceroute, c...
I just received a Cisco 7945, and installed the SIP firmware on it, as I am going be using it at home with a SIP system there.Is there way I can make changes to the phone as far as SIP settings/NTP/button options via a web interface? I am able to se...
I know its been a while, but I haven't had a chance to work on this in a bit So, my issue is that I can see via a tcpdump that traffic is going out over the gre-dmvpn tunnel from R1 to the Cisco. When I check the IP NAT translations, there are none...
I did have to add a route: ip route 10.137.50.227 255.255.255.255 10.22.40.23 (which is the other side of GRE tunnel)Once I did that, yes I can ping the 10.137.50.227 I can ping 8.8.8.8 from the Cisco, yesI have the nat outside on the Cisco WAN int...
