Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to learn dot1q tunneling in GNS3 with IoS. I created a scenario to connect PCs in VLAN2 separated apart with the following switches. The master switch has to be configured to pass vlans 2,3 through vlan100. I am not able to ping PC1 ...
Hi, I have to requirement to tunnel vlans into another vlan. Can someone please suggest a low cost cisco switch that supports this feature. Thanks in advance.uv.
I am using one Cisco SG300. I am trying to simulate two unmanaged switches in the cisco managed switch using VLANs.Port 3 - VLAN 2 - AccessPort 4 - VLAN 2 - AccessPort 5 - VLAN 3 - AccessGlobal STP - DisabledI am trying to test STP of another device....
I am using version 7.2.0.0226. I am trying to set secondary ip address. I tried multilayer switches and routers available in the given components. Setting primary ip is not a problem. But when I try to set a secondary IP address, it gives error. ...
Hi, I am using Cisco packet tracer v 7.2.0.0226. I am using following topology. |LAP|------------(ethernet)--------------|3560 multilayer switch|-----------------(ethernet)---------------|WLC| As a start, I configured management IP address on WLC, c...
Hi Giuseppe, I tried the same topology as suggested by you. Configuration of Master1 is:vIOS-L2-01#show running-config int gi0/0
Building configuration...
Current configuration : 129 bytes
!
interface GigabitEthernet0/0
switchport access vlan 100
...
Hi Pieter,Please let me try to explain my requirment. I am trying to simulate 2 unmanaged switch scenario using VLANs.1. Cisco switch should not process any BPDUs2. If cisco switch receives a BPDU in a port that belongs to VLAN 2, it should be flood...
Hi Rasika, May be this is a different problem to discuss, the GUI(webpage) always shows 'Server Reset Connection'. I did some google , and was suggested to retry many times. One time or the other it pops up.But I tried for 15 minutes, still 'Server...
Hi Rasika, LWAP does not have console in packet tracer. So, cannot do any CLI operations. Please let me know if you have any other ideas. Thanksyuvaraj.
