Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,I'm wondering if you experience the same behavior I am getting from my outdoor AIR-LAP1522A. The access point is powered normal and the switch can detect it from the sh CDP neighbor.in addition, AP is able to reply on ping. but it does...
Hi Cisco Folks Wondering if anyone could advise if you have had the same.I have a power failure in one of my redundant power supply CAT4500-EI bought the new one and I want to replace it I went through the below and I am aware of all what has been m...
Hi Cisco Folks, Hope everyone keeping safe... I have a switch WS-C2960-24TT-L in my store and I was doing some firmware upgrades for some switches at my work store.I found a strange behavior from the output on the console screen, please see attached ...
Honestly, I didn't try because the operation doesn't allow me to have more time for testing.as far as I read I have to do a software upgrade and this model is already EOL.However, I am planning to buy a new Outdoor APs so as long as it works now. I a...
The issue that I have expired certificates and the link I share contains information to resolve this kind of certificate issue.for my case adjust the date to an older date let the AP join and after I put back the current date. That was as simple as I...
Hello Guys, I did not disappear It took some time to get some data and check the console output (on the field)Well, I have 3 AP's 1522, One had an issue to communicate it receive power but not showing on the switch. The other two AP's showing on the...
I had the feeling that the AP had an issue with Hardware and still showing up in the cdp and even still pingable without any issue.the switch port had no changes since the edges and this is the best configuration.Anyway, I plan to dismount it and I w...
