Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to all,I have one CME on 2921 with 4 BRI, I have 2 different ephone-DN user group, I want that a group of user go out with a group of BRI and the other group of user with the others BRI.group1 -->outgoing--> BRI1-BRI2 group2 -->outgoing--> BRI3-BR...
Hi to all,I have a router 888 used to access to SHDLS and as firewall, I try to publish a Exchange 2007 OWA, I do the NAT for port 443 and open the port on firewall, but when I try to connect to the url (https://IPaddress/owa) I obtain a generic erro...
Hi to all,I have a UC520 with last IOS with CME 7.0 version, try to configure a Nokia E55 as internal device using Nokia CC Cisco, in UC520 I configure aephone like this:!telephony-service load 7970 SCCP70.8-5-3Sephone 11 device-security-mode none ...
Hi to all,Can I set an AP (1200 o 1300 series) as client?My problem is that I have to connect a video network camera to a WLAN but I cannot configure it as bridge. So I ask can I associate a AP as client to WLAN and then connect to eth of AP the netc...
Hi to all, I configured on a ASA5510 the interface g0 as outside with sec level 0, g1 as dmz with sec level 50 and g2 as inside with sec level 100.using ASDM I configure dinamic NAT and some static NAT between inside and outside and all works fine. B...
Thank I'll try with traslation rules, I prefer have only one access code.My second question: I have a problem with the pickup-group, I configure on ephone-dn the pickup-group, but not work, any idea, what I have to check?Augusto
