Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to allocate 4 uplinks from N2K to N5K and N5K to N7K. Are there any best practice guidelines for selecting ports (on N5K), based on data plane architecture?Thanks,Jayesh
Hello, I am trying to configure dialback security on a USR3453C (courier) modem. This modem is connected to an AUX port of Cisco 2821. I can dial into the modem and get authenticated and after password verification modem dials me back. After the conn...
Hi,I am using 7.0 on PIX 535A and have 4 different subnets on 4 physical interfaces 10.5.2.144/28, 10.5.2.160/28, 10.5.2.176/28 and 10.5.2.129/30. These interfaces are at same security level 100, I have enabled "same-security-traffic permit inter-int...
Hello Guys,Can anybody point me, as how I can achieve following on Router, Switch and FW.1. Separate logging per context (management and transaction traffic)2. Can logs for each context be send to a separate syslog server3. Can logs for each context ...
Hi, I am trying ACSv4.1.1.23 to use Windows AD database to authenticate TACACS+ clients, can anybody point me to good documentation on site? Thanks a lot.
Thank you for the prompt reply.I was reading below white paper, in the data plane architecture section (fig 5) it mentions 14 independent UPC control 10 G port. My confusion is, if there is any value add in distributing N2K (4 uplinks to N5K) to dife...
