Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys, we're currently experiencing an issue where the the CPU utilization of a Router Cisco2901/K9 is fluctuating constantly between 40% up to 99%.Trying to check which process is the one that is causing the most utilization to try and attack t...
Hi guys, I'm experiencing an strange behavior on a L3VPN MPLS enviorment, and i was hoping you could throw me some ideas on what you think could be going on here.As of security reasons i've changed the ip addresses, maybe a little bit exaggerated on ...
Hello guys.I'm practicing IKEv1 tunnels and trying to set up an IPSec Tunnel to pass LAN traffic thru the tunnel between the 2 sites, and i also want the LAN network on each side to be able to reach "the internet", (i'm using nat overload for this).T...
Hi Balaji,The IOS code the router is running at the moment is this one: flash:c2900-universalk9-mz.SPA.153-2.T.binThe Router only handles up to 2Mbit/s of throughput as that's the WAN link's rate limit.And about the last question the answer is No. Ev...
Thanks for trying to help. I marked you both as solution. The problem has now been solved.Sadly it was impossible for you to solve it because i totally omited a key element. In this MPLS environment, there's also GETVPN involved for encryption betwee...
Now, what's the problem with that? I cannot reach the 10.10.1.0/24 LAN because this line:->access-list 113 deny ip 10.10.3.0 0.0.0.255 10.10.1.0 0.0.0.255if I am not mistaken should read, deny any ip address from the .3.0/24 network from being NATted...
