Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Newbie here.I have two vlans on a single cisco switch. Vlan 10 is is getting its ip address from the dhcp server and internet access from a sonicwall firewall.I added Vlan 20 to that same switch. These two vlans will not or should not communicate wi...
I have setup an inface called DNT-Guest on port 2. Port 2 to a cisco switch that is configured for Vlan 109.I have tested DHCP on a laptop on the switch port which does assign the correct ip address ranng. I Also created a DNT-Guest network under wla...
What i have is this i am not showing all the configuration for security purposes. interface Vlan20description Guest WiFiip address 10.0.109.1 255.255.255.0ip helper-address 10.0.7.201ip default-gateway 10.0.7.9ip route 0.0.0.0 0.0.0.0 10.0.7.9ip rout...
Richard,1) Its a routed (layer 3) link between switch and firewall2) DHCP server is on Vlan 103) the switch i doing some routing4) I have not done this for years. I will look into it.
So I changed the VLAN identifier to 1 and o which did not work.set the port to Trunk mode. Did not work either,Decided to check Guest WLAN settings and removed option "FlexConnect Local Switching" and it worked.Thanks for all the help!!!
