Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I am facing issue getting ESXi boot after fresh installation. My environment is boot from SAN (Pure Storage). Strange part is that I have other UCS blades that are booting fine. Only difference is, hosts that are booting fine were installed b...
Hi All,I am unable to do the cisco hyperflex (Contains 4 nodes) upgrade from and keeps on getting below error. I have already checked firmware/software compatibility before upgrade and also ran pre-check script with no errors/warning in output. ...
Hi,We have existing running Hyperflex cluster with HX version 4.0.2c and vCenter/ESXi hosts 6.7 U3. Hyperflex cluster has DNS suffix that is domain XXXX.com and ESXi hosts name is esx1.XXXX.com, esx2.XXXX.com and so on.Can we change the name of the ...
Hi,I am looking for steps to re-install Hyperflex cluster from scratch. It does not have anything running on it and due to change in design we need to change the replication factor. As we cannot change the RF after installation, so I guess we need to...
Hi,I am getting below error while installing hyperflex via Intersight. Installation is failing at 66%.Failed in Task: Copying Preliminary Software Packages Checksum File to Storage Controller VM(outbound) with error: 'Failed to connect to svc.ucs-con...
Hi Steven, I figured out the problem why this was occurring. In UCS boot policy, SAN boot was configured with vHBA0 and vHBA1 but on storage switches zoning is configured with vHBA2,vHBA3 so after installation when host was rebooting it could not fin...
Hi Steven No, UEFI SAN option does not show up in Boot Menu. Also, I don't see option to add Boot Entry option also in this blade. I checked on other host(ESXi Installed before enabling TPM & Secure Boot) that has same profile(Because created from sa...
Thanks for the response. Yes, I have tried the workflow multiple times but it fails with same error. I have logged case with Cisco and they are suspecting that it is bug on version 4.0(2e), which is the one from which I am upgrading to 4.5(2b)I shall...
Thanks for the reply.Yes, VMware ESXi hosts renaming is straightforward. However, I am looking for information about the impact on hyperflex cluster or recommended approach from Cisco if we want to rename the esxi hosts that are part of Hyperflex clu...
