Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have Catalyst 6509 switch. While doing a routine check i found that it says system minor alarm on power suppy 1 power output failed. I am thinking it is a issue with the first power suppy or its a issue with the twist lock cable. Following is the o...
Hi,I am trying to get few of the sites connected to the main office via the VPN connection using asa 5505/5510. Also the servers on the individual sites need to have internet access of their own with their static ip. I am able to configure the site t...
Hi,I have purchased Cisco 2504 wireless controller and 1142 AP. I was under the assumption that the AP's can be directly plugged into the controller. But it looks like this is not the case. Can anyone confirm it for me please?Thanks
Hi Jouni,Currently there is no ACL for permitting UDP/53 traffic. Also i had attached the complete config for the 2 firewalls at central and remote site when i started this discussion. So you can see that to get an idea. Also the other servers are no...
The servers are configured with the IP address provided by the ISP for the Primary DNS. For some reason the DNS resolution does not work. I have even tried 8.8.8.8 as primary DNS on the servers and still no luck. Also, I just noticed that following c...
We have 4 servers in remote site and only 2 need to have public static ip to go out to the internet. To achieve this i did add the following statements to remote site asa 5505.static (inside,outside) 2.2.2.51 192.168.168.51 netmask 255.255.255.255sta...
