Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just learned something today. When I look at the file size for the same config using the #show run all" cmd .The file is almost 4 times larger than a #show run" cmd. There is a ton of extra stuff going down under the radar. Try a sh run all cmd and...
I have had a breakthrough of sorts. I went on our live network copied the running config (switch#copy running-config tftp:), and then verified it was in the tftp root. I then took the tftp laptop plugged it into the first port on my lab cat 4500 swi...
I just learned something today. When I look at the file size for the same config using the #show run all" cmd .The file is almost 4 times larger than a #show run" cmd. There is a ton of extra stuff going down under the radar. Try a sh run all cmd and...
I was looking at the same thing for basic switch best practices using err disable recovery. Here is what I found.Try to minimize or refrain from using "errdisable recovery" option. This is even more important when used on a chassis-based system like...
I had this logging error and wrote a successful logging discriminator (see below). %C4K_HWFLOWMAN-4-NFEFLINTERRUPT: (Suppressed 107103 times)NFE FL ipv6AddrCompTblMemCorrectedEccErr interrupt.# logging discriminator Dropipv6 msg-body drops NFE FL ipv...
So, my research points to a stale TFTP redirect. I am not sure this is correct, My conclusion is: I do have 3 old redirects which are going to IP addresses that use to be assigned to a TFTP server long ago changed over the years. DHCP has handed out ...
