Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am not sure if this was something that was there earlier. I want to know if there is a way to filter out detailed call history records from the control hub analytics page based on a time range, and also if I can specify the time zone to whic...
There is this small problem with my setup that I can't figure out. What I want to achieve simply is gain remote access to my switch from the laptop. I have two VLAN's for Data and Management,Data VLAN 60 (10.60.0.230/24)Management VLAN 99 (10.61.0.23...
dtibbe, Where in the portal is this? By CDR did you mean call detailed records. I'm assuming it's on the reports section. If so it still gives you to filter by date but not the timezone and time. Correct me if I'm wrong. Regards
I wanted to know if I could have multiple management interfaces. As I can understand now, the only option would be to use a L3 switch and configure a route to the remote network. Correct me if I'm wrong.
Hi Deepak,I agree with you totally. It was just an attempt to figure out if such a thing was possible.In the real world scenario I wanted to gain access to all my Branch switches from HQ and also there is a firewall at the branch instead of the route...
Hi Georg,Thanks for the reply. So if I wanted to have multiple management interfaces configured, would the only option be to replace it with an L3 switch.
