About DGFtw

DGFtw · 10-23-2019

Hi,I'm new to Cisco switches - but somewhat familiar with Alcatel switches.We have a 2 switch stack of identical C2960X switches. One of the switches died and was sent away under warranty, we have been given a new, but completely blank replacement.I ...

DGFtw · 10-25-2019

No unfortunately not, it's a newer version - but I'd rather just downgrade the version to match the master, than upgrade the master (master is in production). I read that it should auto downgrade.I wasn't able to get FTP working because I think I'd n...

DGFtw · 10-25-2019

*cleared as duplicate*

DGFtw · 10-24-2019

Ah okay, apologies again for that.A little stuck on the auto-upgrade command actually, which I understand will synchronize the firmware when adding the new one to the stack. I understand I need to enter config terminal before I enter the 'software au...

DGFtw · 10-24-2019

Hi Paul,I'm really sorry, you are correct - it was a typo, it should say 2960x.Should I disregard your previous post in that case?Thanks,DG

DGFtw · 10-24-2019

Hi Deepak,Thank you for responding to my post.When I try to run that first command on the new switch by entering config terminal, it says 'invalid input detected at ^ marker (pointing at the 'f' on 'conf'). If I try to run the command without enterin...

Member Since	‎10-23-2019 03:58 AM
Date Last Visited	‎02-07-2021 01:56 PM
Posts	7

User Statistics

User Activity

Replacing a faulty switch from a stack with a brand new blank one

Re: Replacing a faulty switch from a stack with a brand new blank one

Re: Replacing a faulty switch from a stack with a brand new blank one

Re: Replacing a faulty switch from a stack with a brand new blank one

Re: Replacing a faulty switch from a stack with a brand new blank one

Re: Replacing a faulty switch from a stack with a brand new blank one