Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community, I tried to describe my issue through the title of this discussion. I have a problem in regards to the connection between the MDS Switches and Nexus Switches at a Customers Data Center. So far we have configured our Ports in this way:...
Hello guys, sorry if this is the wrong section, but because the question is about layer 2 tunneling, I might as well have chosen the right place. So as the title states my L2TPv3 Tunnel is established, but I can't ping my peers in the Same VLAN. I ha...
Hi Everyone, as the title states, I'm interested to know if there is a way to authenticate transparently directly from the Wireless LAN Controller. I'm using a Radius Server with 802.1X for Authentication. The users on their cellphones are getting a ...
I enabled the feature through: feature npivI will check for the npiv enable command, if that is necessary too and I'll reply if that solved the problem. Best,Atdhe
Ping is allowed because it was working. But atm I can't even ping from my switch. I have 3 Switches in 1 HSRP Group, and the Switch on the DRS Side, is seeing the HQ Switches, but it can't ping them, which is strange. Here is the HSRP Output: Vlan63 ...
Here they are:HQ:ASSE_KS_PSTN_GW#show crypto isakmp saIPv4 Crypto ISAKMP SAdst src state conn-id status10.200.201.2 10.200.242.252 QM_IDLE 1057 ACTIVE show crypto session output:Interface: Tunnel1Session...
