Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI everyone
I am trying to sniff 802.11 frames using a 1702i Access Point joined to my controller.
I followed the guide here: https://supportforums.cisco.com/t5/wireless-mobility-documents/collecting-a-wireless-sniffer-trace-using-the-cisco-lightw...
Hi - I had an issue where my AV was fragmenting my packets so they were malformed when they showed up in Wireshark/Omnipeek. As soon as I disabled the AV everything worked as intended.
See the forum post for solution: https://supportforums.cisco.co...
Hi again!
I managed to solve the issue. Apparently Symantec Endpoint Protection was messing up the packets. The AV is running a local IPS system on the host computers. It is setup under "Network and Host Exploit Mitigation Settings" of your client...
Hi Patoberli!
Thank you for taking your time to help
Yes I am capturing on the wired port on my PC.
See attached screenshot. The packets are just regular IP packets like I would except to see under normal circumstances if I just starts to ca...
Hi Scott
Thanks for the quick reply! I am trying the capture filter "udp port 5555", but this filter does not show any packages at all.
I see attached screenshot.
Any advise?
Regards
