Hi,When accessing by the console port, by rollover cable, I just cannot send any character, but i get all the feed back from the switch.Any idea?Here is the config of the con:________________________________________switch#sh line con 0 Tty Typ ...
Hi there,do anyone know about the utility of the "loopback set" flag under the Vlan interface command. Could it help to keep a vlan in up/up state for example?Thanx.
same observation with 2504 (8.5.110.0) and 20-25 AP 1602i with both WLC principal and HA. Syslog messages, come as EMERGENCY (severity), and are persistent:
%BROFFU-0-DP_PACKET_WQE_DIFF: broffu_fp_dapi_cmd.c:6868 Warning: DP Packet pool and WQE p...
Hi Thank's for the information provided.Actually the problem was located at physical level. We simply needed to open the switch and verifying the 8 pins of the female RJ45 connector, one of them were tortured, and everything went OK.Thanks again.gree...
Hi Leo,Thank you for your feedback.I understand that, but what loopback (under vlan interface) does then? i mean what is the difference/utlity to get "loopback set" mention?RGDS,Naz
Hi Daniel,well i already passed the command, and the config, references.In fact i do use loopback as a VSI (e.g. loopback 0 1 etc.) and i am looking to learn more about its interaction/utility with vlan interfaces. (can it makes a non member vlan res...
