About stonent01

stonent01 · 04-10-2024

I accidentally loaded the NPE version of IOS on two 9600's and need to switch to the regular version. I tried with this command:install add file flash:cat9k_iosxe.17.09.05.SPA.bin activate commitand got this response:install_add_activate_commit: STAR...

stonent01 · 01-03-2024

So we have a piece of lab equipment that has to travel inside a vehicle as it gathers data while the vehicle is in motion. It only supports Ethernet in the model that has the specific capabilities that our engineers use. I'm looking for an easily p...

stonent01 · 11-02-2023

We have some of the 9300 5Gb switches with the 1100W PSUs in them. Because of the length they don't fit in some of our older cabinets. What will happen if we swap the 1100W PSUs with the shorter 700W ones from the 9300-48P switches? Specifically I ...

stonent01 · 10-19-2023

We've started getting in the 9300-48UN switches that are several inches longer than the 48P switches we had been getting. (UN switches are UPoE and 5Gb/s, 48P switches are just gigabit PoE+).Now we're hitting rack limitations where a rack is 24" deep...

stonent01 · 09-01-2023

This issue takes place of the course of a few years. I'll say over a year or two ago we had a 3650 stack (3 switches) lock up on us and it wouldn't boot even when fully power cycled (done by my predecessor). It was determined by my predecessor that...

stonent01 · 04-10-2024

Nevermind, it looks like the cleanup was all it needed.

stonent01 · 10-20-2023

My experience is primarily with single or double 3k or 9k Nexus devices. At our main corporate data center (we're a step below them according to our internal rating system) they also use 2k, 5k and 7k Nexus devices, which I have no personal experienc...

stonent01 · 10-19-2023

The basic command structure is about 85% identical. But you will find some commands that aren't identical. The main thing on the Nexus switches is everything is Eth and not Gi or Te like it would be on a catalyst. So instead of Te1/0/1 it would be ...

stonent01 · 09-02-2023

Yeah I'll have the new switch on Tuesday.

stonent01 · 09-01-2023

Hey! I think I may have solved my issue. I powered up this switch today to wipe it in the event of an RMA and after the write erase and reload, I'm getting this, so I think it may have a bad system board.Reload command is being issued on Active unit...

Member Since	‎04-10-2016 11:58 AM
Date Last Visited	‎04-12-2024 12:48 AM
Posts	29
Total Helpful Votes Received	2

User Statistics

User Activity

Convert from NPE to non NPE image?

Wifi to ethernet device that works with a WLC 9800

Swapping 1100W PSUs for 700

Third party mounting to work around longer switches

3650 Stack won't boot with one specific switch

Re: Convert from NPE to non NPE image?

Re: Nexus vs catalyst

Re: Nexus vs catalyst

Re: 3650 Stack won't boot with one specific switch

Re: 3650 Stack won't boot with one specific switch