Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Transferring Crash file from standby:
Login to the Active WLC in HA.
From CLI:
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer upload mode tftp
(Cisc...
Vwlc support only FLexconnect local switching..
https://www.cisco.com/c/en/us/products/collateral/wireless/virtual-wireless-controller/qa_c67-715130.html
So globally mapping interface on wlan will not take effect, you should check in wlan-vlan on f...
It looks like AP trying to upgrade and join the Mobility Express.
Run the below command on ME:
>>> show ap image all
>>> show ap join stats summary all
Follow this process and point the AP image on ME using TFTP:
https://www.cisco.com/c/en/us/td/...
Please check following:
-- AP ip address and wlc management ip are in same subnet.
-- Make sure you don't have any other WLC on same network.
Show commands:
-- Show ap join stats summary all
-- show ap join stats detailed <Ap-mac>
Note:- 8.6.101...
Hi David,
May be if you have AP's in flex-connect you can check below link:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_010010001.html
**********...
May be you can check tac recommended link:
https://www.cisco.com/c/en/us/support/docs/wireless/wireless-lan-controller-software/200046-tac-recommended-aireos.html
Once you choose version check its release notes.
