Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Your profile is not created in the modem. If it's a HWIC or EHWIC or Cisco819 (NIM it's different), you need to type in global something like this, in this case for Bell Canada Mobility with public or private ip, obtained via DHCP (anything in user/p...
My reply is late but maybe it will be helpful to somebody. I never succeeded to make a 819g or hg working correctly on cell with an IOS over c800-universalk9-mz.SPA.155-3.M10.bin, regardless if the modem's firmware is 3.5.10.2 from 2012, or 3.5.29.3 ...
Hello folks,I read since weeks on this problem and I finally figure out how to make that works great, tested on a 4321 runnin ios 16.9.8. I also read many solutions below but no one was completely operational and whitout any flaw under different ISPs...
So many days of reading and finally found this short thread with the right answer! Richard get's right but it MUST be used with the Gianrico's track 10 interface Dialer1 ip routing to works correctly. Tested with Bell Canada's Fibe pppoe. Thank you ...
Hello Daniel, Thanks for this great script, it did the job for many years on my routers! But since a couple of IOSes, (using 15.x 16.x) it looks than the $ipaddress variable is no longer recognized. I looked around many sites to find out what are the...
