Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
need some help here...Trying to setup 4 ports lacp channeled between 6500 (CATOS) and 3560 but ports keep going into errdisable.Here's config with some show output attatched...Switch_6509set port lacp-channel 9/26-29 839set port lacp-channel 9/26-29 ...
A bit of a lengthy one...We have recently installed a new Avaya PABX system (S8700 server and G650 Media Gateways). This connects to a Cisco 2960-48T ...C2960 Software (C2960-LANBASEK9-M), Version 12.2(37)SE.... The problem is when we enable trunking...
Trying to import image from CCO into RME repository. Credentials and proxy authentication all OK and select image and subsets fine when creating job. After job runs, result fails with below message...-----------------Start images downloading:Image 1 ...
Have upgraded from 2.5.1 to 2.6. Since upgrade i'm not getting any syslog notifications. looking at the "Syslog Collector Status" error message 'SLCA0132: Collector Status is currently not available. Check whether the SyslogAnalyzer process is runnin...
How does one change the password of the default 'admin' user in LMS2.5.1. on Windows platform. Problem is that the Server department built the box and installed Ciscoworks and now they have full admin access over our network equipment via Ciscoworks ...
Problem could be at couple of places...Check if DHCP server has correct gateway for VLAN 20.Not sure with Siemens phones.. but worth checking DHCP server if you require an "option" string on Data and Voice VLAN scope. As always, make sure your networ...
