Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I am turing to the community because I have changed settings, ran the acquisition probably 15 times but to no avail. After it completes I have:Number of Acquisition:927Number of host entries:0Number of IP Phone entries:0I have tried ping sw...
I have downloaded these 2 Tcl scripts from this previous discussion and from the sounds of it it's exactly what I've been looking for. But the problem is I'm new to EEM and have no idea how to go about putting these on the switches themselves. I've s...
I have about 185 or so 3750's all runing 12.2(50) IOS. I was hoping someone here could help. We are very big on Layer 2 security and are in the process of implementing 802.1x. We have been disabling ports manually and putting them in a dead Vlan when...
I got them added but they showed up as Not Configured in ACS. So I created a NBG in ACS and came in to work today and now they're authorized and are showing up on the topology map. Thanks again for the help.
Thanks again for the help. I'm using snmp v3 so it was the snmp-server group context vlanid line. Now I just can't fine IP phones. They show up under end hosts but don't show up under IP phones when I run acquisition.
You would compare the MD5 to verify the file is correct and unmodified (someone correct me if I'm wrong). But since you've backed up the IOS now all you should have to do is delete the directory (router#del /force /rec flash:directoryname and then cr...
You have no idea how much work you just saved me. I'm posting the scipt that worked so you can double over it if you don't mind to execute at 00:00 every night. Now if i change the amount of seconds in half would it essentially go off twice a day. Al...
