Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Following along a tutorial, when the tutor runs the command "show vlan" all ports for devices plugged into the switch appear in the list of ports.When i type the same command, the ports with computers connected are missing from the output. (When i se...
I have some CISCO devices (firewalls & switches)I intend to set up a WAN between two locations but both locations are dynamic IP (residential broadband).The IP's of each location do not change regularly but they do change "occasionally".I am new to C...
Win10, PT 8.2.1. I noticed that the tutorial shows all ports as in access mode from the beginning, something which is not congruent with the same device in PT i have. I thought i had done something wrong, but i understand i was not doing anything wro...
