Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to create a DMZ Vlan. Core switch is a 6509. FW is an ASA5520. Need to create a VLAN for DMZ purposes for outside facing servers. NAT is used on ASA. All help is appreciated.
I've started with LMS 2.5 restricted, upgraded with what I thought was a patch to 2.5.1. although my installation bundle says 2.5. Can I apply lms26_update_wink9.zip?
I would like to know if there is a way to allow MS group policy traffic to pass through to a Clean Access protected PC. There is a need to push group policy traffic during boot of the PC and this PC sits on a Clean Access protected network. Also, th...
I have an application called MeetingMaker located behind my pix 515 that is used offsite by 5 users. Since they access this program over the internet, and the users may have dynamic addresses, it it possible to filter these by mac address somehow to...
I found that too in the fact sheet. BTW don't call TAC to find out. They sent me to presales which sent me to TAC. A total waste of time just for one question. Too bad they won't get an order because of that.
Addressing is the next question. Internally on the core I set a VLAN called DMZ-LAN of 10.90.x.x 255.255.0.0. Should I have used an address of one of my class C's instead? example: 192.160.223.x 255.255.255.0
