Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
This week I have bought two 8832 and we have register in our CUCM v.11. When Phone goes to restart it check for firmware and after that it doesn't start it's stay only in state Connecting and we do not have ping any more.
I check in forum for thi...
Hi, At our company we are planning to purchase CallManager. At the moment we have in stock 3 Compaq Proliant DL580 (Xeon MP) servers and I was planning to use one of this to install CM.My qyestion is: Is this possible or not?
hi i loaded the IOS you mentioned and i still have the same problem, it works good without modem-pools when i configure modem pool it doesn't answer the call and it shows this error message..*Feb 23 08:40:50.426: CSM: MODEM_REPORT from 0/3/1:0, call_...
I have same problems (read post below), even that I don't use any NAT/PAT!!!Unified Communications Applications: CUPC 7.0Posted by: MEB-PR - Sep 18, 2008, 2:58am PSTHi there,I have up and running the CUPS 6.0.4 and two days ago I installed CUPC 7.0Wh...
