Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I was checking out the internal wireless settings on a MX67W and found that the option to use Meraki NAT with isolated 10.0.0.0/8 networks is not available. And since the firewall rules only apply up from layer 3 and not in the layer 2 VL...
Hi all,a customer has to do regular power checks in their building which includes testing UPS response times and capacity testing. Since they are running a Prime Infrastructure Appliance in that network it could prove fatal for the database of PI if...
Hi,I have been trying to get a stack of two C9200L switches integrated into a fabric where we are using a non default VN for the fabric.Currently three VNs are shown when checking the fabric,DEFAULT_VN, INFRA_VN and our custom VN. Only our VN is conf...
Hi,I had the same issue today and found that the switch was actually not listening on port 830 at all. It had the same issues as chris described, ssh on port 830 was giving me a connection refused.I found the command "sh ip ports all" that shows the ...
Thank you for the suggestion but I am not trying to isolate the guests from the rest of the network but from each other. I already use a VLAN for the SSID and was just dissapointed to find Meraki NAT (with an isolated 10.0.0.0/8 network for each clie...
I had hoped group policy was an option but I didn't try using it since the only option is to overrides the existing L3 firewall rules and I had already tried using a deny rule for the guest network on the firewall tab.It would surprise me if a group ...
Its also worth checking DNAC -> Provision -> Devices -> Plug & Plug -> C9200L -> History for any errors that may occur as soon as PnP starts.This helped me so much. The stack was visible under Plug&Play Devices. After I deleted the entry I was able t...
Hi and thank you for your input,License is in eval mode, but available for NW and DNA.I am currently on Version 1.3.1.6 but I am also in the middle of the upgrade to 1.3.3.5 which is also not working but thats another topic. I also had this issue in ...
