Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Thanks in advance!
I am running a Nexus 3k switch. At the moment I havea VLAN 50 with a single ACL on it - Inbound. From my understanding this controlls all inbound connections.
If I want to control outbound connections then I need to create ...
Hi,
This might not be the right group for this question, but I need to ask.
So, being a newb to the world of the networking, i ran into a license question.
running sho version i get this:
Licensed features for this platform:AnyConnect Premium Peers ...
Hi,
I am using Cisco ASA 5508-x 9.4
I have some users who connect via any-connect receive:
VPN establishment capability from a remote desktop is disabled. A VPN connection will not be established.
Any ideas?
Hi,
I am new to the world of networking and firewalling (I am the SAN/VMware who was given the "you are the network guy tshirt)
I have a ASA 5508-X running 9.4.
My remote VPN users are currently connecting and are getting IP's from the local IP po...
Hi,
I am new to the world of networking and firewalling (I am the SAN/VMware who was given the "you are the network guy tshirt)
I have a ASA 5508-X running 9.4.
My remote VPN users are currently connecting and are getting IP's from the local IP po...
so if i get the right, the outbound traffic
192.168.6.x/24 ->172.60.0.0/16 and my ACL is applied on vlan 5 (192.168.6.x)
my source traffic is 192.168.6.x?
so if i want to block outbound from 192 to 172
access-list 101 permit tcp 192.168.6.0 0...
ok so
Vlan 5 - 192.168.6.x/24
vlan4 - 192.168.1.x/24
Right now I have (acl status command):
ACL ISOLATED-VM Vlan5 - ingress (Router ACL) Active on interfaces: Vlan5 - ingress (Router ACL)
What I want is to block vlan5 from talking to vlan 4 (but ...
Marius,
config is attached.
I have split networking enabled and the routes are propagated to the client.
I wander if this is my problem:
object network AnyConnect_IPPool subnet 192.168.200.0 255.255.255.0
nat (LAN,OutsideP) source static 10.128.0....
Hi,
So that worked, kind of.
remote users started to receive the IP from the DHCP server. This provided me with the connectivity to the IPSEC tunnel that I could not get to before due to allowed IP range. The thing is I lost connectivity to the in...
